-
May 20th, 2008, 07:21 PM
#1
Senior Hostboard Member
-
May 21st, 2008, 01:02 AM
#2
Senior Hostboard Member
Too bad the $$ is tight,, that is just what I need for my project....
Oh well, it helps to know that there are refurbs out there on these units...
Things are on a turn-around though and I will have more petty cash in hand for things like this...
-
May 21st, 2008, 04:28 AM
#3
Senior Hostboard Member
From what I gather the change to lead free solder caused issues. the newer solder flows differently- and there are a lot of connections on the DSP processor.
My contact at Behringer says the refurbing was just reheating all the connections.
Just wish Behringer would pay for a Smaart driver...
-
May 26th, 2008, 03:29 PM
#4
Senior Hostboard Member
Well, the unit arrived Friday morning.
It did not come with a user's manual or the
box. It did work just fine though. I set up XO points, slopes, gain and time delay in less than 5 minutes and it sounds terrific.(if that is acceptable and not overly verbose). My Stonehenge V speakers are ugly but the early 60's 605s are a treat to listen to the Beatles on:
Rear Speakers
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
This forum has been viewed: 23808158 times.
Bookmarks